How to Install Rubber Stair Treads On Concrete

Rubber stair treads add grip to help reduce slips and hold up well under heavy foot traffic, and installing them is straight forward: measure and cut each tread to size, clean the stairs, apply Double Sided Rubber Stair Tread Tape or contact cement, press each tread firmly into place, add stair nosing if needed, trim the excess, and let the adhesive dry for 12 to 24 hours. Proper preparation and the correct adhesive are what make the installation secure, so avoid all-purpose glue and make sure the stair surface is clean, dry, and smooth. Whether you're a DIY homeowner, contractor, property manager, or just repairing worn stair coverings, the steps below cover the tools you need, adhesive options, trimming, and finishing details for a safe, clean install without glue, nails, or mess. Dry-fit each tread first and make sure it fits tightly against each step before sticking it down.

Materials needed:

• Rubber stair treads

• Measuring tape

• Pencil

• Circular saw or utility knife

• Double Sided Rubber Stair Tread Tape or contact cement

• Utility knife

Instructions:

1. Measure the width and depth of each stair tread and mark the measurements on the back of the new rubber treads with a pencil. Use a circular saw or utility knife to cut the treads to the correct size.

2. Clean the stairs thoroughly to ensure that they are free of dirt and debris.

3. Apply double sided rubber stair tread adhesive tape or contact cement to the back of each stair tread. Make sure to apply it evenly.

4. Place the tread on the stair, lining it up with the front edge of the step. Use a trowel to press the tread firmly in place.

5. If using rubber stair treads on the edge of the stairs, install stair nosing to cover the edge of the stair and provide a finished look. Follow the manufacturer's instructions for installing stair nosing.

6. Repeat this process for each stair tread until all treads are installed.

7. Once all treads are in place, trim any excess rubber using a utility knife.

8. Allow the adhesive to dry according to the manufacturer's instructions before using the stairs (normally 12 - 24 hrs).

It's important to note that these are general instructions, and specific steps may vary depending on the type of rubber stair treads you are installing and the specific installation instructions provided by the manufacturer. Always read and follow the manufacturer's instructions carefully to ensure a proper installation.

Purchase Carpet Tile Tape